Antunes CM-100 - Operating Instructions; Unit Preparation and Preheat; Steaming Procedure; Hi-Limit Thermostat Operation

®
P/N 1011175 Rev. H 08/20
6
Operating Instructions
Preparing Unit
1. Turn the power on and allow the unit
to preheat for approximately 20-30
minutes.
NOTE:ThegreenReadyLightwillash
duringwarm-up.Theashing
light will become steady when
the unit is up to temperature.
If the Ready Light continues to
ashafterwarm-up,orstartsto
ashduringoperation,seethe
Troubleshooting section in this
manual.
NOTE: Do NOT push the Cycle/Start
button during warm-up. The
ashinggreenReadyLight
indicates the unit is not up to
temperature. If the Cycle/Start
button is pressed while the
greenlightisashing,nothing
will happen.
Cooking Procedure
1. Pull out the Spatula and place the
product to be steamed onto the
Spatula.
2. Push the Spatula fully into the unit.
NOTE: Spatula must be fully inserted in
order to start a steam cycle.
3. Press and release the CYCLE/START
button. The green Ready Light will
come on and remain lit for the entire
steaming cycle.
4. At the end of the steaming cycle
(approximately 7 seconds), an audible
signal will sound until the Spatula
is removed from the unit and the
green Ready Light will turn back on,
indicating the product is ready to be
served.
5. Carefully remove the steamed product
and insert the Spatula back into the
unit.
Hi-Limit Thermostat
A hi-limit thermostat will turn o󰀨 electrical
power to the Generator and transformer
circuits if the unit overheats. To reset the
Hi-Limit Thermostat, allow the unit to cool
down (approximately 45 minutes). Then
remove the cap located on the bottom
of the unit (Figure 4) and press the reset
button. If the unit continues to shut o󰀨
due to overheating, contact your Antunes
Authorized Service Agency.
Figure 4. Operation Controls
Figure 5. Cooking Procedure
WARNING
To avoid injury, be careful when
removing the Spatula. Be sure to allow
steam to escape before putting hands
or face over the steamer.
USE R.O. WATER SUPPLY ONLY
CYCLE
START
START
CYCLE
STEAMING
READY
POWER
USE R.O. WATER SUPPLY ONLY
Power Button
Ready Indicator
Light
Steaming
Indicator Light
Cycle Start Button