Anvil FDM-19F02 - Operation; Trigger Control; Changing a Can of Foam

5 HOMEDEPOT.COM
Please contact 1-877-527-0313 for further assistance.
Operation
1
Trigger Control
□ The foam dispensing gun trigger can be metered so the
harder it is pulled, the faster the foam will be dispensed. To
apply foam to smaller gaps, pull on the trigger less. Close
the ow control knob when not in use to prevent premature
discharge.
NOTE: Release the trigger and tighten the ow control
knob to lock the needle in the closed position to prevent
accidental discharge when the gun is not in use.
2
Changing a Can of Foam
□ After emptying a can of Insulating Foam Sealant or Adhesive,
tighten the ow control knob to close it, then remove the
empty can by unscrewing it from the can housing.
□ Clean the can housing with professional Gun Cleaner and
immediately load a new can. Foam dispensing guns include
a ball valve in the can housing to prevent foam coming out
of the top. Uncured foam on other surfaces can be removed
with Gun Cleaner.
CAUTION: Leaving an empty can on a foam dispensing
gun will allow foam to cure inside the gun. Always remove
empty cans and clean the gun when nished.
Foam
Foam