1
Anvil Brewing Foundry™ - V4
©Anvil Brewing Equipment 2019 | www.anvilbrewing.com
Foundry™
Assembly & Maintenance Manual
**** PLEASE READ THOROUGHLY PRIOR TO USE FOR IMPORTANT SAFETY INFORMATION****
What’s Included
Item Quantity
Boiler 1
Malt Basket 1
Dip Tube 1
Valve Assembly 1
Teon Washer 1
Basket Support Ring 1
Lid 1
Knob Washer 2
Screw for Lid 1
Knob 1
Immersion Chiller 1
Hose for Chiller 10 Feet
1/2” Hose Clamps 3
Hose Barb 1
Optional Accessory
Item Quantity
Anvil Pump 1
Silicone Hose 4 Feet
Hose Clamp 4
Flow Clamp 1
Stainless Return Tube 1
Perforated Disc 1
Eye Bolt 1
Nuts for Eye Bolt 2
Recirculation Kit
What’s Included
*120V Standard
Sections labeled “Warning” can lead to serious injury or death if not followed. Please thoroughly read these sections and understand them completely
before use. If you do not understand them or have any questions, contact your retailer or Blichmann Engineering (www.BlichmannEngineering.com)
before use.
Sections labeled “Caution” can lead to equipment damage or unsatisfactory performance of the equipment. Please read these sections thoroughly. If
you have any questions, contact your retailer or Blichmann Engineering (www.BlichmannEngineering.com) before use.
Sections labeled “Important” should specically be followed to ensure satisfactory results with the product.
WARNING:
CAUTION:
IMPORTANT:
1. Do NOT leave this product unattended while in use. The user must remain in the immediate area of the product and have a clear view of the product at all
times during operation.
2. Keep children and pets away from the Foundry™ at all times.
3. The use of alcohol, prescriptions or non-prescription drugs may impair your ability to properly assembly or safely operate this product.
4. Use ONLY on-a level, stable surface.
5. Avoid bumping or impact with the product to prevent spillage or splashing of hot liquid.
6. This product will be hot during use.
7. In case there is a re, call the local re department. Stay clear from ames.
8. This product is not intended or warranted for commercial use.
9. Make sure the Foundry™ is disconnected from all power sources before cleaning.
1. Never operate this product unattended.
2. Never move this product during use.
3. ALWAYS install this product on a level solid surface such as concrete.
4. Heated liquids remain at scalding temperatures long after the brewing process. Never touch the Foundry™ until the liquids have cooled to 115°F (45°C) or
less. The use of heat protective gloves is recommended.
5. Ensure the voltage selector is correct.
6. Use with GFCI protected circuit ONLY.
7. Do not immerse the Foundry™ Boiler in liquid.
8. Do not boil with the lid installed.
9. Operating the Foundry™ in any fashion other than described in this manual can result in personal property damage, injury, electrocution, death, or loss of
seriously good beer.
WARNING
GENERAL PRECAUTIONS
To Next Page
Need help?
General