Anycom Milos-9 - Making a Call; Using Phones Keypad; Using Voice Dial; Last Number Re-dial

Page 6
English - Milos-9
6. Making a call
USING PHONE’S KEYPAD
• Dial number on keypad.
• Press phone’s “send/call” key
• If your phone does not automatically transfer the call to the headset, press MFB for 2 seconds.
USING VOICE DIAL
• Make sure the voice dialling function is set up in the mobile phone and it is within the range of the headset.
• Press MFB on the MILOS-9 shortly. There is a beep tone on the headset.
• Then use your recorded voice commands (e.g. by saying the name of the person).
• The call will be connected in a few seconds.
LAST NUMBER RE-DIAL
• Press and hold volume down button until 4 tones are heard.
• It indicates the re-dial is active
.
7. Ending a call
• Press the MFB briefly to end an active call. You can also end your call from your mobile phone.
8. Reject an incoming call
• Press and hold the MFB for 2 seconds and release button when you hear a beep tone.
9. Answering a call
• Press the MFB briefly to answer an incoming call.
10. Transferring a call
You can transfer a call from the headset to your mobile phone without interrupting the connection:
• Headset to phone: Press MFB for 2 seconds
• Phone to headset: Follow the operating instructions of your mobile phone