EasyManuals Logo
Home>AOC>Monitor>2036S

AOC 2036S User Guide

AOC 2036S
29 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #3 background imageLoading...
Page #3 background image
- 3 -
Precautions
WARNING: Use of controls, adjustments, or procedures other than those specified in this documentation may
result in exposure to shock, electrical hazards, and/or mechanical hazards.
Read and follow these precautions when connecting and using your computer monitor:
PRECAUTIONS
Do not use the monitor near water, e.g. near a bathtub, washbowl, kitchen sink, laundry tub, swimming pool or in
a wet basement.
Do not place the monitor on an unstable cart, stand, or table. If the monitor falls, it can injure a person and cause
serious damage to the appliance. Use only a cart or stand recommended by the manufacturer or sold with the
monitor. If you mount the monitor on a wall or shelf, use a mounting kit approved by the manufacturer and follow
the kit instructions.
Slots and opening
s in the back and bottom of the cabinet are provided for ventilation. To ensure reliable operation
of the monitor and to protect it from overheating, be sure these openings are not blocked or covered. Do not place
the monitor on a bed, sofa, rug, or similar surface. Do not place the monitor near or over a radiator or heat
register. Do not place the monitor in a bookcase or cabinet unless proper ventilation is provided.
The monitor should be operated only from the type of power source indicated on the label. If you are not sure of
the type of power supplied to your home, consult your dealer or local power company.
The monitor is equipped with a three-pronged grounded plug, a plug with a third (grounding) pin. This plug will fit
only into a grounded power outlet as a safety feature. If your outlet does not accommodate the three-wire plug,
have an electrician install the correct outlet, or use an adapter to ground the appliance safely. Do not defeat the
safety purpose of the grounded plug.
Unplug the unit during a lightning storm or when it will not be used for long periods of time. This will protect the
monitor from damage due to power surges.
Do not overload power strips and extension cords. Overloading can result in fire or electric shock.
Never push any object into the slot on the monitor cabinet. It could short circuit parts causing a fire or electric
shock. Never spill liquids on the monitor.
Do not attempt to service the monitor yourself; opening or removing covers can expose you to dangerous
voltages and other hazards. Please refer all servicing to qualified service personnel.
To ensure satisfactory operation, use the monitor only with UL listed computers which have appropriate
configured receptacles marked between 100 - 240V AC, Min. 5A.
The wall socket shall be installed near the equipment and shall be easily accessible.
For use only with the attached power adapter (Output 12Vdc) which have UL,CSA
listed license(Only for monitors
with power adapter).
Please make sure to clean the cabinet regularly with the provided cloth , you can use soft-cleanser to clean the
stain , instead of severe spray cleanser which will cauterize the monitor cabinet.
Dont leak liquid into monitor which will result in the damage of chassis or component. Please unplug before
cleaning ,and do not scratch the screen with hard things.

Other manuals for AOC 2036S

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the AOC 2036S and is the answer not in the manual?

AOC 2036S Specifications

General IconGeneral
Pixel pitch0.2768 x 0.2768 mm
Aspect ratio16:9
Display diagonal20 \
Display resolution1600 x 900 pixels
Vertical scan range55 - 75 Hz
Horizontal scan range30 - 80 kHz
Viewable size diagonal508.05 mm
Contrast ratio (dynamic)60000:1
Viewing angle, horizontal160 °
Display brightness (typical)250 cd/m²
Power requirements90 - 240V, 50 - 60Hz
Display viewable area (HxV)442.8 x 249.075 mm
AC (power) inYes
USB hub version2.0
DVI-I ports quantity0
Power consumption (standby)1 W
Power consumption (typical)25 W
CertificationFCC, CE, CB, CCC, CUL, TUV/S, TUV-Bauart, ROHS, EPEAT, ISO13406-2
Product colorBlack
LED indicatorsStand-by
Tilt angle range-5 - 20 °
Panel mounting interface- mm
Package depth130 mm
Package width558 mm
Package height356 mm
Package weight5900 g
Weight and Dimensions IconWeight and Dimensions
Depth (without stand)186 mm
Width (without stand)496.5 mm
Height (without stand)378.66 mm
Weight (without stand)4500 g

Related product manuals