3
Installation
Do not place the monitor on an unstable cart, stand, tripod, bracket, or table. If the monitor falls, it can injure
a person and cause serious damage to this product. Use only a cart, stand, tripod, bracket, or table recommended
by the manufacturer or sold with this product. Follow the manufacturer’s instructions when installing the product
and use mounting accessories recommended by the manufacturer. A product and cart combination should be
moved with care.
Never push any object into the slot on the monitor cabinet. It could damage circuit parts causing a re or
electric shock. Never spill liquids on the monitor.
Do not place the front of the product on the oor.
If you mount the monitor on a wall or shelf, use a mounting kit approved by the manufacturer and follow the
kit instructions.
Leave some space around the monitor as shown below. Otherwise, air-circulation may be inadequate hence
overheating may cause a re or damage to the monitor.
To avoid potential damage, for example the panel peeling from the bezel, ensure that the monitor does not
tilt
downward by more than -5 degrees. If the -5 degree downward tilt angle maximum is exceeded, the monitor
damage will
not be covered under warranty.
See below the recommended ventilation areas around the monitor when the monitor is installed on the wall or on
the stand:
12 inches
30cm
4 inches
10cm
4 inches
10cm
4 inches
10cm
Leave at least this much
space around the set
To Next Page
Loading...
Need help?
General
