19
Maintenance cycle (NON EU)
You may run this function in one of the following ways:
1). From the OSD menu, manually turn on the image residue elimination function, and select “Yes” from the menu.
During the maintenance cycle the screen will automatically turn off,
and the power indicator will flash. The cycle will take about 10
minutes. Once complete, the monitor will turn off and the power
indicator will go dark.
Do you want to activate Pixel Refresh now?
Yes No
2). From the warning message dialog that appears after every 4 hours of cumulative operation, and select “Yes.”
The monitor has been working continuously for over 4 hours.
Maintenance is now required. During this process the monitor will
automatically turn off, and the power indicator will flash. The
maintenance cycle will take about 10 minutes. Once the maintenance
is complete, the monitor will turn off and the power indicator will go
dark.
Do you want to activate Pixel Refresh now?
Yes No
If “No” is selected, you will be prompted every hour after the monitor has run for 24 hours until “Yes” is selected.
If neither “Yes” nor “No” is selected, the warning message will be repeated every hour after the monitor has run for 24
hours until the user selects “Yes.”
After every 4 hours of cumulative operation, the screen compensation correction and image residue elimination function
will automatically run when the display is turned o, or has been in standby for 15 minutes.
During this operation keep the power on.
The monitor will rst run the screen compensation correction function which will take about 30 seconds. The power indi-
cator will ash white (3 seconds on, then 3 seconds o) during this operation.
Then the image residue elimination function will run which will take about 10 minutes. During this operation the power in-
dicator will ash white (1 second on and 1 second o).
When complete, the power indicator will turn orange for standby mode, or will be o for switch-o state.
During the maintaining, if the user presses the power button to turn the monitor on, the maintaining process will be inter-
rupted and the display will take extra about 5 seconds to turn on.
You may check the number of time the image residue elimination function has run under the “Extra” section of the OSD
menu.
• Auto Warning
If turn o Auto Warning and do not run Pixel Refresh or Panel Refresh within the recommended period, it may cause ima-
ge retention issue on the display.
If turn off Auto Warning and do not run Pixel Refresh or Panel
Refresh within the recommended period, it may cause image
retention issue on the display.
Do you want to turn off Auto Warning now?
Yes No
To Next Page
Loading...
Need help?
General