33
Extra
Exit Enter Select
Extra
LEA
AutoInput Select
Resolution: 3840(H)x2160(V) SDR
H.Frequency: 67 KHz
V.Frequency: 30 Hz
Pixel Orbiting Off
Off
USB Off
USB Selection Auto
Exit Enter Select
Extra
OnAuto Warning
Off Timer
Image Ratio
0
Wide
OffPixel Refresh
Exit Enter Select
Extra
NoReset
Time after Pixel Refresh
Pixel Refresh Counts
4
0.7
Time after Pixel Refresh
Pixel Refresh Counts
4
0.7
DDC/CI
Yes
Input Select
Auto/ HDMI1 / HDMI2 / DP/
USB C
Select Input Signal Source
USB
O/ High Resolution/High
Data Speed
For model need to turn on/o USB power during
power saving.
The default USB setting is O. If you want to
connect USB-C device, please adjust the USB
setting to High Resolution or High Data Speed.
USB Selection Auto / USB C / USB up Select the USB upstream data path.
LEA
(Prevention
of local image
retention)
On/ Off
It is used to turn on the LEA function to reduce the
risk of generating image retention. Recommended
function settings: “On.”
After this function is enabled, the screen will be
automatically narrowed to x the brightness of
the display area, so as to reduce possible image
retention.
Pixel Orbiting
(Image shift)
O / Weak /
Medium /Strong / Strongest
It is used to turn the Pixel Orbiting function on
to reduce the risk of generating image retention.
Recommended function setting: “On.”
After this function is enabled, image pixels will
circularly move as a whole. The movement
amplitude is based on the settings. The moved
character may be side cut. When “Strongest”
is selected, image retention is most unlikely
generated, but possible side cut may be most
notable.
Auto Warning O / On
When O is selected, this warning will pop up, and
the warning will not be set to Time out until the user
selects Yes or No. If End user selects No, Auto
Warning will be set back to On
To Next Page
Loading...
