NOTE：
Power/ Auto Configuration
• Do not place the monitor close to heat sources such as heaters, ventilation ducts or places exposed to direct
sunlight.Do not place it at dusty places or places that make the machine shake or impact either.
• Keep the original package box and packing materials; if you need to transport your monitor again, they will
come in handy.
• For maximum protection, please pack the monitor the way it was packed when shipped out of the factory.
1.Power
2.Analog (DB-15 VGA cable)
To protect equipment, always turn off the PC and LCD monitor before connecting.
1 Connect the power cable to the AC port on the back of the monitor.
2 Connect one end of the 15-pin D-Sub cable to the back of the monitor and connect the other end to the computer’s
D-Sub port.
3 Turn on your monitor and computer
.
To Next Page
Need help?
General
