12. Safety Guide and Maintenance
Important
For your safety, please carefully read the following guidelines for the device:
1. Do not operate the device under abnormal conditions.
2. Avoid looking directly at the device's tracking beam or pointing the beam at
anyone's eyes. Please note that the tracking beam is not visible to the naked eye
and is set as always-on.
3. Do not disassemble the device (this will void the warranty) and do not attempt to
operate under abnormal current loads.
4. Keep the device away from liquid or moisture. Operate the device only within the
indicated temperature range: 0 ° C (32 ° F) to 40 ° C (104 ° F). If the temperature
of the device is too high, unplug the device to lower the temperature.
5. If the RGB lighting is not running properly, or the device is not functioning, or if
there is an abnormal thermal situation, troubleshoot the device by unplugging
the device and plugging the device back in .
6. If the troubleshooting process does not resolve the issue, unplug the device and
visit www.aoc.com for support. Do not attempt to repair the device yourself.
Safety
Federal Communication Commission Interference Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference that
may cause undesired operation.
Note:
This device has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
device generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this device does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of the
following measures:
—Reorient or relocate the receiving antenna.
To Next Page
Loading...
Need help?
General
Weight and Dimensions