Connecting to a PC
1. Turn off the HDTV and PC.
2. Connect a 15-pin D-Sub RGB (VGA) cable
to the RGB output of your PC and the
other end to the VGA input at the rear of
the HDTV.
3. Connect the Audio Out on your computer
to the AUDIO input at the rear of the
HDTV.
4. Turn on the HDTV and PC.
5. Select VGA using the SOURCE button on
the remote, side of the HDTV or directly
by pressing the HDMI/PC button on the
Remote.
NOTE
For the best picture quality when
connecting a computer through VGA, set
your computer timing mode to native
resolution of panel. Please refer to the PC
or graphic card’s user guide for additional
information on how to set the timing
mode and the video output requirements
of the product.
To Next Page
Loading...
Need help?
General
