Voltage / resistance or temperature measurement C
NTA47230-300A6 69 / 101
Attention, the choice of °C or °F is made in the Setup\Preferences\temp unit menu.
Using the F1 key, define the CSF used by positioning the cursor on it (for TC6621, TM6602 and TM6630 units
only).
Enter the menu by pressing F2.
Using the navigation keys ( and ), choose the CSF (OFF: None, ON: internal or programmed).
Press VAL to confirm.
Press VAL (again) to confirm the desired function and go back to the measurement screen.
The Measurement mode makes it possible to display the Min (bottom left), Average (bottom centre) and Max values
(bottom right) from the last RAZ Min/Max command.
Access this command by pressing the F2 key.
Using the navigation keys ( and ), position the cursor in the RAZ Min/Max field.
Confirm the latter using the VAL key.
Note:
Following a significant thermal shock, it is advisable to allow the device to stabilise its temperature to use the
internal reference junction (CSF) with the utmost precision (TC6621, TM6602 and TM6630 units).
To Next Page
Loading...
