Need help?Do you have a question about the AOMWAY Commander V1S and is the answer not in the manual?
General| Brand | AOMWAY |
|---|---|
| Model | Commander V1S |
| Category | 3D Glasses |
| Language | English |
Highlights key features including displays, RF modules, HD input, DVR, OSD, and ventilation for user comfort.
Covers FOV, lens type, display resolution (854x480 WVGA), and LED backlight.
Details Side/Side 3D support and adjustable interpupillary distance (59-69mm).
Lists operational controls (brightness, channel, DVR) and NTSC/PAL auto switch video format.
Covers 720p HD input via C-type interface and DVR recording specifics (TF card, MJPG).
Mentions modular head tracker and dual 64CH diversity RF receiver.
Lists items such as Carry Case, AV cable, JR cable, Futaba cable, adapter, foam, manual, and antennas.
Explains long press for head tracker activation/deactivation and single press for anti-fog fan.
Details DVR recording controls, menu navigation, and playback functions.
Covers display mode selection, RF input control, contrast, and brightness adjustments.
Explains band selection, channel selection, auto scan, and display feedback.
Identifies TF card slot for DVR recording, supporting up to 32GB.
Describes earphone port (3.5mm) and antenna SMA jack connector.
Details AV in/out, IPD sliders, head tracker port, DC power input, HD interface, and ventilating fan.
Requires TF card formatting for DVR recording and safe insertion/removal procedures.
DVR is for analog recording only (RF/AV mode); files auto-save on power loss.
Explains modularity, connection to radio controller, and two operation modes (360 gimbal, 90 pan/tilt).
Details how to reverse pan/tilt direction using Key 1 for correct servo movement.
Advises checking radio controller channel and servo setup if head tracking fails.
Requires Key 3 for HD 2D/3D mode and supports 720p@60fps via mini HD interface.
Connect cable before powering on; power off to refresh memory when changing signal source.
Uses 3.5mm 4-pole AV jack; switch off RF for AV mode to avoid conflict.
Supports 3.5mm 3-pole audio jack for adjustable volume earphones.
Features slots for -2, -4, or -6 diopter lenses; requires removing foam cover.
Uses 5.5*2.1mm DC barrel connector (7-18V, 2S-4S battery).
Details voltage thresholds for 2S, 3S, and 4S batteries triggering low voltage alarm.
Describes buzzer sounds for initialization, channel/band changes, head tracker status, and auto scan.
Checks power supply, channel frequency, transmitter status, and display mode settings.
Verifies servo cable connection, data cable, trainer function, and connector security.
Addresses interference, environment, SMA connectors, antenna mounting, and frequency settings.
To Next Page