English
External controls
1 & 2
LED Indicator/Power button
Turns the monitor on/off. Blue indicates power on. Amber
indicates standby/power saving mode.
3
Function Key
/ /
a. Press to view the OSD.
b. Press this button to select the desired item when in OSD
menu.
4
Function Key
/ /
a. Use the Contrast hotkey to adjust Contrast. (Only VGA
Model)
b. Press this button to select the desired item when in OSD
menu.
4
Function Key
/ /
a. Use the INPUT hotkey to enter Input select function. (Only
HDMI Model)
b. Press this button to select the desired item when in OSD
menu.
5
Function Key
/
a. Press this button to adjust Brightness.
b. Press to enter a selection in the OSD.
6
Function Key
/
a. Press this button to select scenario modes.
b. When the OSD menu is active, this button will act as the
exit key (exit OSD menu).
Regulations and safety notices
FCC notices
This device has been tested and found to comply with the limits for a Class B digital device pursuant to
Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This device generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this device does cause harmful interference to radio or television reception, which can be
determined by turning the device off and on, the user is encouraged to try to correct the interference by one
or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the device and receiver.
• Connect the device into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/television technician for help.
CE declaration of conformity
Hereby, AOPEN SmartView Inc., declares that this LCD monitor is in compliance with the essential
requirements and other relevant provisions of EMC Directive 2014/30/EU, Low Voltage Directive 2014/35/
EU, and RoHS Directive 2011/65/EU and Directive 2009/125/EC with regard to establishing a framework for
the setting of ecodesign requirements for energy-related product.
Notice: Shielded cables
All connections to other computing devices must be made using shielded cables to maintain compliance
with EMC regulations.
Notice: Peripheral devices
Only peripherals (input/output devices, terminals, printers, etc.) certified to comply with the Class B limits
may be attached to this equipment. Operation with non-certified peripherals is likely to result in interference
to radio and TV reception.
Caution
Changes or modifications not expressly approved by the manufacturer could void the user authority, which
is granted by the Federal Communications Commission, to operate this product. In order to prevent damage
to the monitor, do not lift the monitor by its base.
To Next Page
Loading...
Need help?
General
