-
Turn ON/OFF the scooter:
To Turn ON:when the scooter is off,press power button shortly
To Turn OFF:when the scooter is on,press power button for 3 seconds
-
Turn ON/OFF the lights:
To turn on/off the lights(front and rear),press power button twice in a row,when
the lights are on,display reflect it(1 in the diagram)
-
Switch KM to Mile:
Press power button 3 times in a row to switch kilometers to miles
- Start Mode
Press power button 4 times in a row to switch from zero start mode to non-zero
start (kick-to-start)
(The default setting of electric scooters is non-zero start. Zero start means
directly pressing the accelerator to start)
-
Switch dual motor to single motor(Note: single motor models do not need
to operate)
The factory default is to start with dual motors. After use, it will memorize the
drive mode used last time, and it will not memorize under abnormal conditions. (For
example: switch to the rear motor after booting up, and then remove the battery
directly or turn off the battery power without shutting down)
Click the motor switch to cycle in sequence (dual motor -- rear motor -- front
motor -- dual motor)
When the motor is switched to single motor, there will be 1 beep of "di..." and 2
Beeps of "di..." for dual motor.
To Next Page
