-
Total mileage display:
Press twice motor switch to display total mileage
There may be a mileage value display after leaving the factory, this value is the
test value.
Manufacturers normally use confidential permissions to clear test values after
testing.
-
Adjusting brake disc
When the brake is too tight or to loose,use 5mm Allen wrench to loosen the screw
on the caliper. Slightly adjust the brake line to suitable place,then tighten the screw.
-
Adjusting handle bar
Prolonged use of the scooter may cause screw to loosen,making the handlebar
shaft unstable,when it occur,just tighten two screws located on the folding
mechanism.
3.
Charge the scooter
Removal battery set and dual charging port design with 2 chargers available at
the same time.(default package only provides 1* charger)
1. Lift the rubber flap from the bottom of the electric scooter
2. Plug the charging adapter into the charging port
To Next Page
