Instruction
1)
Charge the lithium battery in the temperature range of 0°C to +45°C.
2)
Keep charging for 6-8 hours.
3)
Only use the dedicated charger to charge your scooter.
4)
Local charger AC input voltage (100~240v).
5)
Turn off the power before charging.
6)
Make sure the charger is connected to the scooter first, then pluggedin.
Otherwise the charger hole may be damaged.
7)
Do not place the charger and board in a damp place, not near water.
8)
Note: Keep away from other items by not less than 20 cm, not on the sofa,bed
or carpet. Do not cover the charger and keep it ventilated.
9)
Do not place any weight or heavy objects on the scooter and charger.
10)
Unauthorized modification of the scooter is prohibited, otherwise the warranty
will be voided and the risk of injury and electricity will be created.
11)
The light is red when charging. When the battery is full and the light turns green,
unplug it. Do not recharge the battery within 2 hours.
12)
Please be under the supervision of people when charging.
Charging failure
If a malfunction is detected during charging, stop charging.
Check the following conditions:
If the charging indicator is off, please check whether there is AC power and make
sure that the power cord is fully connected to the charging port.
If AC power is present and the charging indicator is off, it means there is a problem
with the charger. Contact the distributor of the scooter.
Please do not use different types of chargers when charging. Only use a dedicated
charger. Do not use one charger to charge several different electric scooters. The
charger may be damaged during work.
Do not disassemble the charger, please contact the scooter distributor when you
need to repair or replace it.
Surface charge (partial charge)
Whenever you have not fully charged the battery of the scooter, surface
charging or partial charging may affect the accuracy of the dashboard display,
making it display a higher battery level.
After turning on the power, observe the dashboard, and then ride for at least
three to four minutes, and check the power display on the dashboard again. During
this period, the battery display is less, indicating that the battery has only received
surface charge. If necessary, need to push it back to charge.