★NOTE
①Check wiring diagram, power supply, control signal.
②Don’t change the internal wiring.
③If the power supply is 3 phase, check the rotating direction.
④Enable the electric actuator lies in a half on/off position by manual, turn on electricity and input open signal.
⑤If the electric actuator runs to the open direction, the wiring is correct.
⑥If the running direction is opposite, change 2 pieces wiring in 3.
11、Maintenance
Lubrication: Because special Mo-based grease is long life and well resistance, so no need to refuel;
Regular operation: Drive and check the device regularly when valve works infrequently.
★ Note: Debugging description of modulating model, please refer to the specification of the actuator controller
part.
To Previous Page
Loading...
Need help?
General
