14
OPERATING PROCEDURES
7. Toseetherunningtime,orcurrentsegmentthesystemisprocessingorthe
temperature of the external temperature probes. repeatedly press the
selectionbuttontoswitchbetweendifferentviews.Followthesuffixguideto
determinedisplayedtemperature.
8. Aftertheprocessisfinishthedisplaywillshow“End”, themiddleandbottom
displaywouldshowthetemperatureoftheprobes.Presstheincreasebutton
tosavetheprofileandexittoprofileadjustmentmode.
9. To exit before the process is finished press the increase button while the
profile is running. The system would exit and return to profile adjustment
mode.
***Analternativewaytosavetheeditedprofileistorepeatedlypresstheselection
button until the display shows “SaveProf 0” (the bottomdisplaynumbershould
correspondto the selectedprofile).Presstheupbutton tosavethesettingsand
jump to profile selection screen. This option is availableonly for newer software
versions.
Note: There is a built in protection feature to automatically limit the
temperaturerisingslopetonomorethan3degreespersecond.Therefore
themaximumsettemperaturewillbebasedonyoursettime.
PreloadedProfile0:
SEG1SEG2SEG3SEG4SEG5SEG6
090t110t150t050t060t60t
150C180C210C190C210C230C
Segmentoneissetto50secondstoreach150C.Whichmeansafter50secondsat
theendofsegmentonethetemperatureshouldreach100C.ThenSegmenttwois
set to 110 seconds toreach150C, which meansby theendof 60 seconds(total
running time after segment two is already 50+110=160 seconds) the set
temperatureshouldreach150C,soonandsoforth.
3
CARE and SAFETY PRECAUTIONS
CAUTION: Improper usage can cause injury and physical damage.
For your own safety, please observe the following precautions.
● Temperaturemayreachashighas500°CwhenturnedON.
Donottouchtheheatingelementinsidethepreheater.
Donotexposeskintoinfraredlightforlongperiods.
Prolongedexposuremaydamagetheskintissue.
● Handlewithcare
Neverdroporsharplyjolttheunit.
ContainsdelicatepartssuchasIRtubesthatmaybreakiftheunit
isdropped
Donotspillanyliquidtothesystem.
● Do not tamper the electrical control unit or any wiring inside the
device.
● Disconnectplugfrommainpowersourceifthedevicewillnotbeused
foralongperiod.
Turnoffpowerduringbreaks,ifpossible.
● Allowampletimefortheequipmenttocooldownbeforecommencing
maintenance.
● Use only genuine replacement parts. Turnoff powerand let the unit
cooldownbeforereplacinganycomponent.