3/ 6
"tAnPErSt": select "tAnPErSt" using the right/left buttons in the service menu, then press
and hold the sealable button for at least three seconds until "SUCCESS" appears.
Note: The tamper reset operation, deleting of influence signals may be carried out only if
the meter is properly installed and no tamper is in progress. There are three basic criteria
for proper commissioning: connection of the meter according to the wiring diagram,
installation and fixing of the terminal cover on its place and the presence of mains. If any
of these conditions are missing, the reset cannot be performed an "Error" message is
displayed on the LCD.
According to the display sequence parameterized during the production, the Active energy
consumption value with its OBIS code (1.8.0.) is presented on the LCD in 8 digits, (7 whole and 1
decimal place).
In addition to the measurement data and its OBIS identification code, several other symbols can
be displayed in the upper part of the LCD according to the drawing below. The L1, L2, L3
symbols indicate the correct / incorrect connection of the mains voltage as described in
Terminal block housing and connection.
Displayed measurement data in case of default automatic display sequence:
To Next Page
Loading...
