APC Symmetra LX - Extended Setup Options

CHAPTER 4: MESSAGES
16
PowerView
Message
Meaning Corrective Action
AC adequate for UPS
but not for bypass.
The UPS will function on-line with
the input voltage, but in the event
that bypass is required, the input
voltage is not adequate to power
the load equipment.
Option 1: Improve the
incoming voltage.
Option 2: Proceed with
startup. Normal bypass is
not available.
Start-Up
(continued)
Low/No AC input,
startup on battery.
Input voltage is not adequate to
start the UPS. If startup proceeds,
the UPS will function from battery.
Option 1: Abort startup until
acceptable input voltage is
present.
Option 2: Proceed with
startup. Battery will be
discharged.
# of batteries
increased.
At least one battery module has
been added to the system.
# of batteries
decreased.
At least one battery has been
removed from the system.
# of Pwr Modules
increased.
At least one power module has
been added from the system.
Intelligence Module
inserted.
An intelligence module has been
installed in the lower IM slot.
Intelligence Module
removed.
An intelligence module has been
removed in the lower IM slot
Redundant
Intelligence Module
inserted.
An intelligence module has been
installed in the upper IM slot.
Redundant
Intelligence Module
removed.
An intelligence module has been
removed in the upper IM slot.
# of External Battery
Cabinets increased.
At least one external battery
cabinet has been connected to the
frame.
General
Status
# of External Battery
Cabinets decreased.
At least one external battery
cabinet has been disconnected
from the UPS.
No corrective action
necessary.