7
Turn on feed water:
Slowly, turn on your
Cold water supply. Turn
counter-clockwise to
allow the raw water to
enter the system.
Check for leaks!
Turn on the cold water
faucet and let it flush the
new system for up to 5
minutes.
Hold on to the new filter with the label side facing you
and align the two teeth indent to the two teeth on the cap.
After the filter and the cap is align, gently push up and
turn Clockwise until it locks in place. Gently pull down to
make sure the filter is secure in place.
4
5
6
7
* * * End Filter Change Section * * *
To Next Page
Loading...
Need help?
General
