Apec Water Instant Hot User Manual

1
Please read and become familiar with the instructions before
proceeding with the installation.
Before Installation:
Inspect the system:
Please take the system and all the components out of box. Inspect the system and all
the connection fittings carefully, making sure everything is in good condition during
shipping. If any part is broken, please do not proceed with the installation and contact
APEC or your distributor for an exchange or diagnosis.
Copyright:
This manual is copyrighted by APEC Inc. Under the copyright laws, this manual may not be
reproduced in any form, in whole or part, without the prior written consent of APEC Inc. Manual
print ver. 3.1, 2021Sep.
General Installation/Operation/Maintenance Requirements
• Installation needs to comply with state and local laws and regulations.
• Do not use with water that is microbiologically unsafe or of unknown quality without
adequate disinfection before or after system.
• Recommended tool: end nipper.
Installing the Instant Hot System with RO System
A). Installing the instant hot system with the RO System
If you are installing the instant hot system with the RO system together please follow
the RO system manual for RO setup. When you get to Step 4: Mounting The
Faucet, please follow the steps indicated in this manual.
B). RO system already installed previously, you need to change to Hot &
Cold Faucet
Turn OFF cold water supply to RO system, and turn OFF tank’s ball-valve. Lift up RO
faucet lever briefly to relief the built-up pressure inside the RO system, remove current
RO faucet, and replace with a new hot & cold faucet, then follow the steps indicated
in this manual.

Apec Water Instant Hot Specifications

General

Brand	Apec Water
Model	Instant Hot
Category	Water System
Language	English