29
Part II: Trouble-Shoot Guide
For Newly Installed RO System
After installation, if you encounter any of the problems described below, please follow this guide to
troubleshoot. In most cases, the problem is quickly solved by following this guide.
52+HDG3RLQWV,GHQWL¿FDWLRQ
Point A: Feed water inlet into Stage-1 filter (red tubing)
Point D: Stage-4 Membrane housing inlet port. Feed water from Stage-3 filter enters the
Membrane at this port.
Point E: Check Valve. The filtered water from the Membrane passes through this Check Valve
before entering the storage tank. The Check Valve blocks the tank water from
back-flowing into the membrane.
Point F:
T-fitting on Stage-5 filter. This end of the T-fitting connects to the CLEAR pure water line.
Point G: T-fitting on the Stage-5 filter. This other end of the T-fitting connects to the YELLOW pure
water line which goes to the tank’s valve.
Point H
: The output end of Stage-5 filter. Pure water leaves Stage-5 filter via this port, and flows
onto the dispensing faucet.
Fig. 16
P
rt II: Tr
l
-
h
t
i
For Newly Installed RO System
A
ter installation, i
you encounter any o
the problems described below, please
ollow this guide to
troubleshoot. In most cases, the problem is quickly solved by
ollowing this guide.
2+HDG3
LQWV,GHQWL¿FDWL
Q
P
int
ed water inlet into Stage-1
ilter (red tubing
P
nt D
Stag
4 Membrane housing
nl
port. Feed water
rom Stage-3
ilter enters the
embrane at this por
P
nt E
Check Valve. The
iltered water
rom the Membrane passes through this Check Valve
be
ore enterin
the stor
e tank. The Check Valve blocks the tank water
rom
back-
lowing into the membrane.
P
nt F
-fitting on Stage-5 filter. This end of the T-fitting connects to the CLEAR pure water line.
P
int
-fitting on the Stage-5 filter. This other end of the T-fitting connects to the YELLOW pure
water line which goes to the tank’s valve.
P
int
Th
output end
Stage-5
ilter. Pure water leaves Stage-5
ilter via this port, and
lows
nto the dispensing
aucet.
Fig. 1