BR5N-1-OMA-103a 12
3.4
Setting the ID number
1. Press “No” key, and set the ID number (1 ～ 25)
2. Press “SET” key.
Then, ID No. can be set.
3. Set ID Number with the following keys.
[A
AA
A-
--
-Z
ZZ
Z] ： Alphabet/Numeral Change key
(The display shows “NUM” or “ALP” according to the condition.)
[
▲],[▼] ： Select key for alphabets and numerals.
[
],[
] ：
Move cursor at inputting alphabets and numerals.
[
0
00
0
]
～
[
9
99
9
] ： Inputting numerals.
[
],[
➪
] ：
Move cursor.
[DEL
DELDEL
DEL] ：
Delete the letter on the cursor
[SET
SETSET
SET] ：
Fix and memorize the characters shown on the LCD display.
[EXIT
EXITEXIT
EXIT]
：
Quit the storage and end the procedure.
Up to 8 letters can be used for the ID numbers.
The basic parameters are memorized even after the power switch is turned off.
3.5
Other functions
Following parameters can be set for BR-5000N.
Confirm the present state of parameter before measurement.
SET 0 : Standard CONC 10.0 ～ 30.0 mg/㎗
SET 4 : Printer Use 1:on, 2:off
SET 5 : Auto-Print 1:on, 2:off
SET 6 : Comm(RS-232C) 1:on, 2:off
SET 7 : Baud rate 1:9600, 2:19200, 3:34800 bps
SET 8 : RS-232C mode d:Data bit 7/8, s:Stop bit 1/2
p:Parity bit odd/even/none
3.5.1 The setting of standard solution
1. Press “SET”, and then “0” key.
The standard concentration value at present can be seen.
2. Set CONC value with the following keys.
『０』～『９』 ： Input numerals.
Decimal point is fixed, and the effective range is
from 9.0 to 30.0.
[DEL] key clears the displayed numbers to “0.0”.
3. Press “SET” key.
The datum is fixed and memorized.
Display comes back to “Ready” without memorizing the data when “EXIT”
key is pressed.
No. 5 ID
No. 5 IDNo. 5 ID
No. 5 ID-
--
-
To Next Page
Loading...