BR5N-1-OMA-103a 13
3.5.2
The setting of Printer
Choose whether Printer Interface is active or not.
. 1. Press “SET”, and then “4” key.
2. Choose the condition with [1]/[2] keys.
On : Printer effective
Off : Printer ineffective
3. Press “SET” key.
The condition is fixed and memorized.
Display comes back to “Ready” without memorizing the data.
when “EXIT” key is pressed.
3.5.3 The setting of Auto-Print
When “Auto-Print is ON, the measured data are printed automatically on the printer
after each measurement. When it is OFF, data can be printed with the “PRINT” key.
1. Press “SET”, and then “5” key.
2. Choose the condition with [1]/[2] keys.
On : serial output effective
Off: serial output ineffective
3. Press “SET” key.
The condition is fixed and memorized.
Display comes back to “Ready” without memorizing the data
when “EXIT” key is pressed.
* Even when the “Auto print” is off, the measured data can be printed out after the
measurement with [PRINT] key.
3.5.4 The setting of ＲＳ－
ＲＳ－ＲＳ－
ＲＳ－２３２
２３２２３２
２３２Ｃ
ＣＣ
Ｃ output
Choose whether RS-232C Interface is active or not.
1. Press “SET”, and then “6” key.
2. Choose the condition with [1]/[2] keys.
on : Serial output effective
off : Serial output ineffective
3. Press “SET” key.
The condition is fixed and memorized.
Display comes back to “Ready” without memorizing the data
when “EXIT” key is pressed.
To Next Page
Loading...