17
If the device does not function properly:
1. Make sure the battery is properly installed, or replace the battery. Be sure to observe proper
polarity markings when replacing the battery. If the low-battery indicator appears when the unit is
turned on, replace the battery and check again.
2. If the intensity has been adjusted and there is no stimulation, check that the lead wires are
properly connected and the electrodes are in place. If the unit appears to be functioning and no
stimulation occur, the lead wires or electrodes may need to be replaced.
3. If the battery appears to be charged and the unit is not functioning, turn both intensity Control
Knobs to the OFF position (counter clockwise) for about 7 sec. Then gradually turn the
intensity Control Knob clockwise until stimulation is felt. If device still is not working, turn the unit
off and contact your distributor.
If any other problems occur, please consult or return the device to your distributor.
Don’t try to repair a defective device.
TROUBLESHOOTING
To Next Page
Loading...
