QUICK START GUIDE
DT250
Easy 3 Step Installation
Converter Box Installation
Composite/AV Connection
Auto Program
Scan Channels
1
L
AUDIO R
CH 3
CH 3/4 &
Analog Pass-Through
CH 4
S-VIDEO
VIDEO
SMART
ANTENNA
Yellow
Yellow
Video Input to TV
Over-the-air Antenna
Connect your over-the-air antenna
to your converter box
Connect Video/Audio inputs
GREEN LED - ON
RED LED - OFF
Back of Converter Box
Audio L / R Input to TV
White
White
Red
Red
Thank you for your purchase of the Apex Digital converter box. Remove the converter box from packaging and
proceed with the following steps for optimal connection and experience.
Change your TV input mode to
VIDEO/COMPOSITE.
Power converter box ON. An
“Initial Setup Menu” will automati-
cally start up. Use the arrow
buttons to select “Auto Program”
and press “OK” to initialize.
Allow the progress bar to scan
untill 100% for all available digital
channels. Once Auto Program
scan is complete, the first scanned
channel will display.
** If your TV does not have composite/AV inputs, please refer to the Page 9 in the User’s Manual for RF connec-
tion. Your converter box and TV must be set to the same receiving channel (CH3 or CH4) in order to view digital
channels. Receiveing channels may vary between CH3 and CH4 depending on your location.
* In order to receive digital signals, you MUST connect an over-the-air antenna to your converter box.
* Channels may be deleted or added after Auto Program Channel scan. Please refer to page 15 in the User’s
Manual for more information.
For additional questions, please visit our website www.apexdigitalinc.com or call us at (866) 427-3946 Monday-Friday, 8am-5pm PST.
2
3
Auto Program Menu
Searching Channels
Progress (%) 100
Scanning
Initial Setup Menu
Menu Language
Time Zone
TV Aspect Ratio
Auto Program
To Move To Select To Exit
OK EXIT
English
Pacific
Auto
2
2
2
1
1
1
POWER
ANTENNA IN
TV OUT
To Next Page
Need help?
General
