3. Operation
NOTE - Before first use, the nebulizer cup assembly should be cleaned following instructions
described in the “Cleaning” section.
WARNING - Before connecting the power cord, make sure the I/O (ON/OFF) switch is in the
O (OFF) position.
The plug is also used to disconnect the device. Do not position the equipment so that
it is difficult to disconnect the device.
The device is also equipped with a plug to enable connection to the electric power
supply.
3.1 Daily Use Operation
CAUTION - The Mini Plus Compressor is designed for intermittent use only. Do not operate
it continuously for more than 30 minutes for a single use without turning it off
and allowing a cooling period of at least 30 minutes.
1.
Before each use inspect the Mini Plus Compressor and nebulizer cup assembly for damage or
wear, and replace as needed.
2.
Place the Mini Plus Compressor on a table or other flat stable surface. Be sure you can easily
reach the controls when seated. Do not use this device on the floor.
3.
With the power switch in the O (OFF) position, plug the power cord into an appropriate
electrical wall outlet.
4.
Connect one end of the tubing to the compressor air-outlet connector.
5.
Assemble the nebulizer cup and add indicated medication to the nebulizer cup before use.
6.
Attach the other end of the tubing into the air-inlet connector at the bottom of the nebulizer cup.
7.
Turn on the Compressor by pressing the power switch to the I (ON) position and begin
treatment.
8.
If treatment needs to be interrupted, simply press the power switch to the O (OFF) position.
9.
When the treatment is complete, turn off the compressor by pressing the power switch to the O
(OFF) position and unplug the unit from the electrical outlet.
Equipment not suitable for use in the presence of a flammable anesthetic mixture with air or
with oxygen or nitrous oxide. This device has no AP or APG protection.
To Next Page
Loading...