DEPLOYMENT AND INSTALLATION
Place the DLI meter wherever measurements are desired. To accurately measure PPFD incident on a horizontal
surface, the sensor must be level. The ¼-20 threaded mount can be used to secure the meter in place and ensure
consistent measurements. The mount also allows the use of most commercially available camera mounts, tripods,
and various stakes. The DLI meter comes with a yellow soil stake for easy, immediate deployment.
NOTE: The meter is officially IP65 rated against incoming dust and water. The meter is not rated for full immersion.
While some users have reported successful deployments underwater at shallow depths and short durations, doing
so may cause adverse effects or meter failure. Meter failure due to immersion is not covered by warranty.
To Next Page
Loading...
