U S E : -20℃～60℃ (-4 ～ 140
°F)
STORAGE : -20℃～45℃ (-4 ～ 113
°F)
CHARGE : 0℃～55℃ (32 ～ 131
°F)
Temperature range for battery
WARNING
WARNING
CAUTION
CAUTION
● Altering the battery connector plug in any way is very dangerous and
should not be done. Any alterations will cause unexpected trouble.
● The battery is quite heavy, so be careful not get your fingers pinched
or to drop it onto your feet.
● Hold and squeeze the release levers on both sides of the battery connector
plug and pull upwards.
● Hold the battery grip firmly and lift it away from the body.
Place in on a clean and dry flat stable surface.
● After connecting the AC plug of the charger to a domestic outlet, connect to the battery.
● The connector is polarized, so when connecting, insert in a direction so it will smoothly enter
the connector receptor.
CAUTION
● Please do not set the battery into the scooter for at least 30 minutes after completing the charge as the battery
continues to emit hydrogen gas. Please keep clear of an open flame.
● LED 1 will indicate the red light when connect AC plug to a domestic outlet.
● LED 2 change from the red light to green when charging is completed.
● The green light of LED 2 shows when no connecting to the battery.
LED 2 will indicate charging status.
Charging : Red light
Finished : Green light
The battery charger automatically changes into trickle
charge mode after charging is complete however please
avoid leaving the charger connected after the charge
lamp becomes green.
① At first, turn the power off and remove the
AC plug from the domestic outlet.
② Next, remove the battery connector.
■STEP4 Releasing the battery connector plug.
■STEP5 Removal of the battery.
■STEP6 Connecting the single-purpose charger to begin recharging.
■STEP7 Disconnect the charger when charging is completed.
■STEP8 Charge completion.
Charging time of the charger
① First, connect the AC (alternating current) plug of the charger to a domestic outlet.
② Next, connect the DC58.8V output connector from
the battery to the connector receptor plug on the
charger. The charging will automatically start upon
connection after the power is turned on at the
domestic outlet.
AC100~240V
AC plug
110V
Inlet voltage selector
220V
110V
↑
↓
● Set the inlet voltage selector to AC voltage of your region.
90~132V: Set to110V position / 200~264V: Set to 220V position
To Next Page
Loading...
Need help?
General
