1 2 3 4
First, fold down the stem of the scooter.
Locate and remove the two screws shown
above by turning them counter-clockwise using
a 5mm allen wrench.
Use the included hex key to tighten the screws high-
lighted on the following graphics.
Your scooter motor creates vibrations when you ride it,
which may cause the screws on your scooter to loosen
over time. We recommend checking your screws
every few months to make sure they remain tight. You
can use a medium strength headlocker adhesive to
further improve their stability.
23
2
3
4
1
Screw Tightening
Proceed to reassemble the folding latch and
ensure that the two screws are torqued to
25NM.
Once the folding latch has been removed you
will then have access to the main direction bolt.
Ensure that this bolt is properly torqued to the
recommended 50NM.
To Next Page
Loading...
Need help?
General
