6
Attach handlebar
Locate the headlight at
the top of the stem, and
identify two screws holding
it attached to the handlebar
clamp. Using the included allen
key, gently unscrew the two
screws.
Once completed, you will
see the light fixture come
off from the clamp, revealing
a total of four screws on the
handlebar clamp. These four
screws hold the handlebar
inside of the clamp. Proceed to
unscrew all four of these screws
until the front half of the clamp
comes off.
Go ahead and grab the
handlebar, placing it
inside the clamp. Make sure
to position it correctly - the
throttle should be on the right.
If you have another person near
you, now may be a good time
to ask for their help holding the
handlebar still.
Then pick up the allen key
with one of the screws,
and gently start turning clock-
wise. Next, pick up another
screw and go in the diagonal
hole from the first screw. This
way you will create enough
pressure between the two
screws to hold the handlebar
still.
Once you notice the han-
dlebar is becoming more
fixed in place, stop tightening
the screws. Take a moment to
adjust the handlebar - ensure
it is centred and the handles
are at a comfortable angle. If all
looks good, grab the remain-
ing two screws and continue to
tighten the clamp until you can
no longer turn the screws.
1
3
5
2
4
1
4
5
2
3
To Next Page
Loading...
Need help?
General
