APOLLO3D SATURN 10Plus - User Manual

This guide only applicable to Apollo3D Saturn 3D printer
USER GUIDE
APOLLO3D SATURN10/10Plus

APOLLO3D SATURN 10Plus Specifications

General

Wavelength	405 nm
Power Input	100-240V, 50/60Hz
Power Consumption	120W
Build Volume	219 x 123 x 250 mm
Light Source	LED
Connectivity	USB
Operating System Compatibility	Windows

Summary

Notice

2. First Installation

2.1 Leveling

Guides users through the process of leveling the printer's heat-bed for optimal print adhesion.

2.2 Loading and Unloading Filament

Explains the procedures for correctly loading and unloading filament into the printer's extruder.

3. Operation

3.1 Filament

3.1.2 Print Setting

3.2 Print Start-up

Instructs users on how to start a 3D print job from an SD card or USB stick.

3.3 Model Removal

Explains safe methods for removing finished models from the build plate without damaging the printer.

4. Introduction of Touch Screen

6. Maintenance

6.1 Maintenance and Service

6.2 Extruder Unclogging

Provides step-by-step instructions to clear filament clogs from the extruder.

6.3 Daily Maintenance and Use Suggestion

7. Support and Service