506/506B
EN
Auto-Hold
Maximum / Minimum Record
When measuring, you can press the A-HOLD button to start
the Auto-Hold mode. In this mode, the meter holds reading
and shows it on the secondary display.
If the dierence between new reading and hold reading is
bigger than 5d (3¾-digit mode), and new reading is also
stable, then meter automatically holds a new reading on the
secondary display.
When reading is smaller than Auto-Hold limit, or reading is
OL, the Auto-Hold mode is not working.
When measuring, you can record the maximum, minimum
and average value of reading.
To use maximum / minimum record mode, move the blink
cursor of menu to MAX, MIN or AVG position, and press
the ENTER button to enter mode. In this mode, the meter
records each data to compare the maximum and minimum
value. Also, meter calculate the average of reading.
You can move the blink cursor of menu to MAX, MIN or AVG
position, and press the ENTER button to select result on the
secondary display.
When maximum / minimum record mode running, if you
wants to pause recording, press the A-HOLD button. Press
again to continue.
To exit maximum / minimum record mode, press the
CANCEL button.
To exit Auto-Hold mode, press the A-HOLD button again. If
you don’t want to use the Auto-Hold mode, you can disable
it in the setup mode. When Auto-Hold mode is disable, the
hold mode is not update any new reading.
Function Limit
V, A, LoZ, Hz, Cap 1% of range
Others No limit
To Next Page
Loading...
