APPA 703 - Display and Data Features

The Zero mode records the current input value as reference
and appears on the sub display. The after input values will
subtract the reference value and display on the main display.
To use the Zero mode, follow the steps below.
1. Press the Zero button to enter Zero mode. The “Δ” appears
on the display.
2. Press the Zero button again to record a new input value as
reference.
3. Press the Zero button for 2 seconds to exit this mode.
Select Display Count
• Press the 2000 /20000 button to select the display count.
Zero
EN
703
13