EasyManuals Logo

APRILIA ETV mille User Manual

APRILIA ETV mille
352 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #45 background imageLoading...
Page #45 background image
ETV mille
PERIODIC MAINTENANCE AND ADJUSTMENTS
2
- 10 - 00
Release 00/2004 - 04
2
3
4
1
2.3.6 SETTING THE CLOCK (HOURS AND
MINUTES)
NOTE The clock can only be set when the motorcycle
is at standstill.
& Hold down the MODE button (1) for over three
seconds. The hour segments (2) will start to flash.
NOTE Press and release the SET button (3) alternately
to change hours in one-unit increments. Hold down the
SET button (3) to cycle through hours quickly.
& Press the SET button (3) and set hours.
& Press and release the MODE button (1) to confirm. The
minute segments (4) will start to flash.
& Press the SET button (3) and set minutes.
& Press and release the MODE button (1) to confirm.
NOTE The clock will reset automatically whenever the
battery is removed from the vehicle.
2.3.7 INSTRUMENT AND INDICATOR CHART
Description Function
Direction indicator LED light
Flashes when a direction indicator is operated.
High beam LED light
Comes on when headlamp high beam is turned on or when the high beam
flasher is operated.
Rev. meter (rpm)
Gives engine speed in rpm.
Never exceed maximum engine rpm.
Fuel reserve LED light
Comes on when fuel level in the tank drops to 4 Ø 1 l.
Refuel as soon as possible when this light comes on.
Side stand LED light
Comes on when the side stand is down.
Oil pressure LED light
Comes on whenever the ignition switch is set to and the engine is
stopped to test LED operation.
If the oil pressure LED “ ” stays on
after engine has been started up, or comes
on while the engine is running, it means that pressure in the engine
oil circuit is too low.
Neutral LED N light Comes on when gearbox is in neutral.
Diagnostics LED light EFI
Comes on and stays on for about three seconds whenever the ignition
switch is set to " to test LED operation.
The diagnostics LED “EFI” will flash to
indicate that the on-board computer has
detected some failure event. This may occur while the engine is
running or as soon as the ignition switch is operated. Normally, the
engine will keep running though performance may be somewhat
impaired. The wording “EFI” only lights up on the multifunction
digital display during service inspections by Aprilia Franchised
Dealers.
Speedometer (kph) Gives road speed.
CONTINUED
WARNING
WARNING
WARNING

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the APRILIA ETV mille and is the answer not in the manual?

APRILIA ETV mille Specifications

General IconGeneral
BrandAPRILIA
ModelETV mille
CategoryMotorcycle
LanguageEnglish

Related product manuals