THE VEHICLE SHOULD NEVER BE WASHED IN DIRECT SUNLIGHT, ESPECIAL-
LY DURING SUMMER, WITH THE BODYWORK STILL HOT, AS THE SHAMPOO
CAN DAMAGE THE PAINTWORK IF IT DRIES BEFORE BEING RINSED OFF.
DO NOT USE LIQUIDS AT TEMPERATURES OVER 40 °C WHEN CLEANING
PLASTIC PARTS OF THE VEHICLE.
DO NOT AIM HIGH PRESSURE AIR/WATER JETS OR STEAM JETS DIRECTLY
TO THE FOLLOWING PARTS: WHEEL HUBS, CONTROLS ON THE RIGHT AND
LEFT SIDES OF THE HANDLEBAR, BEARINGS, BRAKE PUMPS, INSTRUMENTS
AND GAUGES, MUFFLER EXHAUST, GLOVE-BOX/TOOL KIT COMPARTMENT,
IGNITION SWITCH /STEERING LOCK, RADIATOR FINS, FUEL TANK CAP,
HEADLAMPS AND ELECTRICAL CONNECTIONS.
DO NOT USE ALCOHOL, PETROL OR SOLVENTS TO CLEAN RUBBER AND
PLASTIC PARTS. USE ONLY WATER AND NEUTRAL SOAP INSTEAD. DO NOT
USE SOLVENTS OR PETROL BY-PRODUCTS (ACETONE, TRICHLOROETHY-
LENE, TURPENTINE, PETROL, THINNERS) TO CLEAN THE SADDLE. USE IN-
STEAD DETERGENTS WITH SURFACE ACTIVE AGENTS NOT EXCEEDING 5%
(NEUTRAL SOAP, DEGREASING DETERGENTS) OR ALCOHOL. DRY THE SAD-
DLE WELL AFTER CLEANING.
CAUTION
DO NOT APPLY PROTECTIVE WAX ON THE SADDLE AS IT MAY BECOME SLIP-
PERY.
Transport
CAUTION
BEFORE TRANSPORTING THE VEHICLE, EMPTY THE FUEL TANK WELL AND
MAKE SURE IT IS PERFECTLY DRY.
DURING TRANSPORT, THE VEHICLE SHOULD BE AT ALL TIMES UPRIGHT AND
WELL ANCHORED SO AS TO AVOID FUEL, OIL OR COOLANT LEAKS.
92
To Next Page
Loading...
Need help?
General
