APsystems ECU-R - Module

APsystems ECU-R Installation/User Manual
18
4. ECU-R User Interface
 Status of connectivity

The traffic light (on the left) in front of the ECU UID shows
connectivity status between smartphone or tablet and ECU
hotspot:
 Smartphone or tablet is connected to the ECU hotspot.
 Smartphone or tablet is not connected to the ECU hotspot. Please
try again by pressing the AP button.
 The traffic light (on the right) shows connectivity status between
the ECU and the local internet:

The ECU is connected to the local internet.
 The ECU is not connected to the internet.
Other info visible from the home page
power output of the day
-Total power output since installation
-CO₂Reduction since installation.
4.9 Module
 This page displays the microinverters entered in the ECU (via the
Menu ID Management) and properly registered by the ECU.
A dual microinverter will be shown by default with 2 PV modules, while
a quad microinverters will be shown by default with 4 PV modules.
if some DC channels are not connected on purpose, the ECU_APP will
nonetheless continue to display the maximum number of panels which
can be connected to a given microinverter.

Removing un-used channel needs to be done from the EMA installer
account when creating end-user account.
 On the module page, installer can visualize the performance of
microinverters registered into the ECU.

Click “Panel”: the detailed information of the microinverter is
displayed, including inverter UID, PV module DC power, grid voltage,
frequency and temperature.