APsystems ECU-R - Default Chapter; Table of Contents

APsystems ECU-R Installation/User Manual
1
Table of Contents
1. Introduction
........................................................................................................................................
2
2. Interface Explanation
.....................................................................................................................
3
2.1 Interface Layout
...................................................................................................
3
2.2 Reset
.......................................................................................................................
4
2.3 Power Connection Port
....................................................................................
4
2.4 RJ45 Ethernet Network Port
..........................................................................
4
2.5 RJ45 Signal (Only for Australia)
....................................................................
4
2.6 Antenna
..................................................................................................................
4
2.7 USB port
................................................................................................................
4
2.8 AP
.............................................................................................................................
4
2.9 LED1
.........................................................................................................................
5
2.10 LED2
......................................................................................................................
5
3. Hardware Installation
.....................................................................................................................
6
3.1 Preparation
.............................................................................................................
6
3.2 Selecting an Installation Location for the ECU-R
....................................
6
3.3 Installation
.............................................................................................................
6
3.4 Cable Connection
...............................................................................................
7
3.5 Internet Connection
...........................................................................................
9
4. ECU-R User Interface
....................................................................................................................
10
4.1 Commissioning the ECU-R
.............................................................................
10
4.2 Enter microinverters UID (serial numbers) into the ECU-R
...............
11
4.3 Historical ID
........................................................................................................
12
4.4 Delete UID
...........................................................................................................
12
4.5 Grid Profile
..........................................................................................................
13
4.6 Time management
...........................................................................................
14
4.7 ECU Network Settings
....................................................................................
14
4.8 Checking the commissioning of the ECU-R
............................................
17
4.9 Module
.................................................................................................................
18
4.10 Data
.....................................................................................................................
19
4.11 Inverter Connection Progress
......................................................................
19
4.12 Automatic System Check
.............................................................................
20
4.13 ECU AP Settings
..............................................................................................
20
4.14 Do-It-Yourself Registration
..........................................................................
21
4.15 Settings
...............................................................................................................
21
5. Technical Data
.................................................................................................................................
22
6. Contact Information
.....................................................................................................................
24