APsystems ECU-R Installation/User Manual
3. Hardware Instrallation
2）Installation inside a power cabinet
Install the socket on the guide rail (The socket is not be supplied by
APsystems).
Connect the adapter to the power connection port at the back of
the ECU-R.
Figure 6
ECU antennas must be left outside of the cabinet, even if the cabinet is
made of plastic. Please make sure the extension antennas are Wifi
2.4GHz with SMA connectors male/female. These extension antennas
are not supplied by APsystems, but can be purchased at any
electrical/PV shop.
To Next Page
Loading...
