EasyManua.ls Logo

Aqua OASIS - Components - Filtration

Aqua OASIS
16 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
COMPONENTSTechnical module – Filtration systems
CARTRIDGE FILTRATION
Filter cover cap
The filter and its cartridge play a very important role.
A clean cartridge largely contributes to good water quality,
adequate suction and propulsion of the pumps as well as
the proper functioning of the electronic box and keyboard,
that is to say, without the appearance of error codes.
Filter cover
Clamp ring
MAINTENANCE OF THE FILTRATION CARTRIDGE
Before cleaning the filtration cartridge, it is
essential of:
Ring lock
Clamping
- Turn off the electrical current to your spa (turn the
electrical circuit breaker to position
STOP
).
- Close the water access valves to the technical module.
Then, by unscrewing the tightening ring (do not forget
to raise the lock) then removing the cover of the
cylindrical receptacle of your spa's filtration system, you
will find a filtration cartridge (also called filter).
This must be removed from its receptacle once every 2
weeks
then rinsed vigorously using a garden hose in
order
to dislodge most of the dirt found there.
A
more thorough cleaning should be done once every 1
or 2 months depending on the use of the spa. To do this,
you will need to obtain a cartridge cleaning solution
which you will mix with water following the proportion
instructions indicated on the bottle. Leave to soak for a
few hours then rinse thoroughly. It is always best to allow
the cartridge to dry completely before putting it back into
the filter tank.
Filtration cartridge
Model: PleatcoPRB50
Model: UnicelC-4950
Filter
cartridge
It is recommended to have a second replacement
cartridge while you are cleaning as you should never
leave the spa running without a filter cartridge to avoid
major mechanical damage. It is also recommended to
replace
the cartridge with a new one every 1 or 2 years.
Cleaning the
cartridge
filtration
Pay particular attention to putting the cover back in
placeas well as the seals of the filtration system to
avoid significant water loss.
NEVER FORGET TO Raise THE WATER ACCESS VALVES
TO THE TECHNICAL MODULE BEFORE RETURNING ON
ELECTRICAL POWER.
9