COMPONENTSTechnical module - Pumping system
PUMP(S) (Motor)
Covered with
the strainer
The pump circulates the water, in a closed circuit, between the pool and
the technical module so that it is freed of its impurities by the filter and
heated by the water heater, before returning to the pool via the jets.
'water.
Pump (Motor)
No special maintenance is necessary. It can remain outside
during the winter period, whether it is in use or not.
The only attention to pay to it is to:
- Make sure that the water access valves are all in the “OPEN” or
“UP” position before turning on the electrical current.
Strainer
Pump
- Unscrew the strainer cover and add water to it during the initial
start-up or the first start of the season.This important operation
aims
to initiate
the pump when starting.
- Follow the recommended steps carefully during the winterizing
process if you do not wish to use your spa during the cold
season. Refer to the WINTERIZING PROCEDURES chapter for
details.
WATER ACCESS VALVES
Water access valves must be in positionOPEN AT ALL TIMES when the
electric current is energized.
There is an access valve for each of the water inlets and outlets included in the
technical module.
The only time it is permitted to put them in positionFARM, is during a
technical
service operation without emptying the spa pool (
ex. when
cleaning the filtration cartridge or during a repair to the technical
module)
.
Water access valve
in position ''
OPENED''
Water access valve in
'' position
CLOSED''
7
To Next Page
Loading...