CLOSURE PROCEDURESTechnical module
For the technical module
Using the wet/dry sweeper, you must vacuum up the water
trapped in the components of the technical module.
Pump
Unscrew and remove the drain plug on the front of the pump (impeller).
Vacuum up any remaining water. Store the cap in a dry place.
Pump strainer
Unscrew and remove:
- the transparent cover
- Cart
- the drainage plug at the bottom of the strainer
Vacuum up any remaining water. Close the strainer cover then store
the baskets and caps in a dry place.
Filter
Remove the filtration system cover and cartridge. Clean then
store the cartridge in a dry place. Vacuum up any remaining
waterat the bottom of the filtration cylinder. Close the filter
cylinder cover.
Cover(s) of the
strainer
Strainer basket(s)
Suck up the remaining water through the holes in the pipe
unions at the pump inlet and at the filter outlet.
Screw in all pipe joints to prevent rodents from getting in
during the winter.
Close the cover of the technical module and place a tarpaulin to
protect it from the introduction of water.
Filter
cartridge
ATTENTION
NEVER PUSH OR PROPELL SNOW ONTO OR INTO THE SPA. Regularly and even
During the winter, you must regularly check the draining well if there appears to be an
accumulation of water under the pool. In such a case, it is necessary to evacuate the
groundwater to avoid the phenomenon of lifting or displacement of the basin.
15
All rights reserved | V220922
To Previous Page
Loading...