COMPONENTSBasin
Note that some components may be optional.
THE JETS
The flow rate of each jet can be controlled by turning it to the left
(less powerful/closed) or to the right (more powerful/open). The
jets can also be removed.
To get there, grab then turn the entire jet to the left; once completely to
the
left, continue to exert tension towards the left in order to disengage
the
"screwing" mechanism with which the jet is equipped so that it can
remain
in place.
Jet
JET MAINTENANCE
We recommend cleaning the jets quarterly: Remove the jets then
place the jets in a container filled with water to which you have
added a small amount of dish soap. Swirl the rotating nozzles in
the soapy water solution then rinse them thoroughly.
SKIMMER
The skimmer (type A or B) is placed on the top of the spa wall. It is
used to suck up surface water as well as dirt to transport it to the
filtration system in the technical block.
Never stand directly in front of it or let any
object obstruct its front.
Skimmer
Type A
Skimmer
type BMake sure the water level is always at least halfway up
the plastic skimmer plate (ideally the top 2/3).
The bottom drain(s)
The drain(s) are placed on the bottom of the spa wall (calf height). It is
used to suck up bottom water as well as dirt to transport it to the
filtration system in the technical block.
Bottom drain
Never stand directly in front of it or let any
object obstruct its front.
Take care to regularly clean the front(s) of the drain(s) so
as not to reduce the flow of water entering it.
5
To Next Page
Loading...