To Next PageTo Next Page
Need help?Do you have a question about the Aquacal 120 and is the answer not in the manual?
General| Model | Aquacal 120 |
|---|---|
| Category | Heat Pump |
| COP (Heating) | 5.0 |
| Max Working Pressure | 50 PSI |
| Heating Capacity | 120, 000 BTU/h |
| Power Supply | 208-230V/60Hz/1-Phase |
| Refrigerant | R410A |
| Operating Temp Range (Heating) | 40°F to 104°F |
| Sound Level | 65 dB |
Details the patented heat exchanger made from titanium for durability.
Highlights the ability to heat and cool pool or spa water.
Explains the active defrost feature for continuous operation in cold weather.
Explains the meaning of WARNING and CAUTION signals used in the manual.
States that the heater contains no owner-repairable components.
Emphasizes that refrigerant circuit service requires certified professionals.
Highlights risks of hyperthermia and improper water chemistry.
Instructions to ensure the unit has electrical power connected and operational.
Guide for setting heating mode, pool/spa selection, and temperature.
Steps to start the heating process and ensure water flow.
Detailed explanation of buttons, lights, and the LED display on the control panel.
Critical safety warnings regarding electrical shock and pressure cleaners.
Recommendations for maintaining proper water chemistry for longevity and safety.
Information on protecting the unit from freezing conditions.
Crucial warnings and instructions for winterizing the heat pump.
Diagnosing issues when the heat pump does not start or operate.
Troubleshooting steps for when the unit runs but does not heat effectively.
Diagnosing whether water around the unit is condensation or a leak.
A flowchart to guide users through diagnosing operation failures.
A flowchart for troubleshooting heating performance issues.
A flowchart to diagnose water leaks or condensation issues.
Detailed instructions for installing the heat pump.
Procedures for configuring and adjusting the heat pump controls.
Safety warnings for owners and technicians regarding repairs and refrigerant.
Guidelines for placing the heat pump outdoors, including clearances.
Details required clearances for optimal airflow and service access.
Required water flow rates for proper heat pump operation.
Illustrates correct water inlet and outlet connections for optimal performance.
General guidelines for electrical installation, including disconnect location and conductor types.
Requirements based on National Electrical Code (NEC) and local codes.
Guidance on sizing electrical service based on the equipment data plate.
Guide on how to operate the digital controller for heating pool or spa.
