SAVED WAYPOINT SAILING (SWS)
Waypoints can only be stored when the boat is sailing in Manual Mode
Saving a location into the Auto Pilot
Step 1: Ensure the boat is in Manual Mode i.e Sail Mode Switch is in center position.
Step 2: Locate the SWS function switch on the right front face of the remote. Move the
switch to the ON position i.e facing down.
Step 3: Locate the bait tray release switch on the top right corner of the remote. Press the
switch to store the co-ordinates of the boats current location.
In this mode the bait tray release switch instructs the Auto Pilot to store the co-ordinates of
the position the boat is in when the switch is pressed.
Activating the SWS feature
To instruct the boat to sail to a stored waypoint follow these steps:
Step 1: Select Auto on the S/M switch (position 3 - the position closest to the rear of the
radio).
Step 2: On reaching the stored destination waypoint the boat will stop. Follow the usual
pre-bait deployment instruction detailed above before dropping the bait.
Step 3: After deploying the bait, select Manual mode and sale the boat 5 to 10m deeper
and around 30m to the right or left of your fishing line before engaging RTL mode to
autonomously sale your boat back to shore.
Deleting waypoints
The stored waypoint data will not be lost when the boat is turned off. To delete waypoint
info follow these steps:
Step 1: Turn ON the SWS function switch (facing down)
Step 2: Press and hold the bait release switch and turn ON the boat.
Step 3: Keep the bait release switch pressed while monitoring the LED display on the boat.
Step 4: As soon as the LED starts to consistently flash blue or green release the bait tray
release switch.
To Next Page
Loading...
General