Baiting up
Using the bait tray for smaller baits
To open the bait tray
Push the spring-loaded bait tray release lever located on the rear of the boat below
the bait tray. This will release the flap and open the bait tray. Place your baited hook
into the bait tray.
To close the bait tray
Simultaneously push the flap back down to closed position and push the bait-tray
release lever inwards. Hold the flap in place and let go the release lever to secure the
flap.
The two stainless steel pins can be used to secure the trace.
Use the left pin to hang the sinker just on the outside of the bait tray.
Use the right pin to hold the line. Place the last eye of your swivel onto this pin.
Place your fishing rod in a vertical sand rod holder and set a slight drag on your reel
but ensuring that when you tug on the line, the fishing line releases smoothly from
the rod.
Towing larger baits behind your boat
Bait recommendation
Ensure the baits are hydrodynamic (ideally a whole fish or slender cuts) so that they
are able to plane behind the boat once it is moving at sufficient speed.
Tow the bait 2 inches / 5cm behind to help reduce drag and preserve your battery.
Sinker / weight recommendation
Option 1
Hang the sinker / weight off the left pin on the bait flap instead of dragging it behind
the boat. This setup creates virtually no excess drag and will help prevent putting
your boat under unnecessary strain.
To Next Page
Loading...
General