Fit and connect the horizontal battery first, pushing it all the way back into the boat.
Place the second battery vertically into the boat with the terminals facing forward. The
batteries must be seated so the tops of the batteries are level and parallel to the deck.
Connect the negative terminal then the positive terminal to this battery. Ensure the
terminals fit tightly. Now turn on the boat (switch facing backwards).
The moment the boat is turned on it will emit a double beep sound. This indicates that
the speed controller is powered.
Check that the external digital meter on the deck of the boat lights up. The full battery
voltage is 26.5 volts
If no Auto Pilot is fitted, a single beep will be emitted 2 - 3 sec later. This indicated that
all electronic circuits are working and the throttle levers are in a neutral position.
If your boat is fitted with Auto Pilot please refer to the A/P instructions on page 10.
OR
Step 4(b) - Lipo battery pack:
Install a single 22.8 Volt Li-on pack into the boat as follows:
Fit and connect the battery pushing it all the way back into the boat. The battery must
be seated so that the top of the batteries is level and parallel to the deck.
Connect the negative terminal then the positive terminal to this battery. Ensure the
terminals fit tightly.
Check that the external digital meter on the deck of the boat lights up. The full battery
voltage is 25 volts.
The moment the battery is connected, the boat will emit a double beep sound. This
indicates that the speed controller is powered.
If no Auto Pilot is fitted, a single beep will be emitted 2 - 3 sec later. This indicated that
all electronic circuits are working, the throttle levers are in a neutral position and you
are ready to continue
If your boat is fitted with an Auto Pilot module please refer to the A/P instructions
on page 10.
IMPORTANT: DO NOT TEST YOUR NEW AQUACAT TURBO X IN A SWIMMING POOL! The
boat is very powerful and will most likely be damaged against the sides of the pool.
To Next Page
Loading...
General