Need help?Do you have a question about the Aqualisa Colt and is the answer not in the manual?
General| Type | Thermostatic Mixer Shower |
|---|---|
| Maximum Static Pressure | 10 bar |
| Temperature Control | Thermostatic |
| Installation | Wall Mounted |
| Inlet Connection | 15mm |
| Outlet Connection | 1/2 inch |
| Safety Features | Automatic shutdown if cold water fails |
Illustrates the setup for gravity-fed shower systems, detailing pipe connections and component placement.
Shows the configuration for pumped shower systems, highlighting pump integration and water flow paths.
Details the installation for combination boiler systems, including necessary connections and safety considerations.
Presents the installation diagram for Unvented Hot Water (UHW) systems, showing typical connections.
Illustrates the setup for thermal storage unit systems, focusing on water flow and connections.
Lists all parts included for the exposed shower valve and Harmony head assembly.
Shows all components for the concealed shower valve and Harmony head installation.
Prepare wall recess, fixing points, and pipe entry for concealed valve installation.
Remove the temperature lever and fit the shroud.
Fit elbows, outlet connectors, and connect supply pipes to the valve body.
Install the flow regulator for specific heaters and manage the outlet cap.
Install mortar guard, wall plate, and shroud for a flush finish.
Refit temperature rings, shroud, and secure the control knob.
Mark fixing points using a template and prepare the wall surface for the exposed valve.
Assemble valve body, fit supply pipes, and refit shrouds.
Cut supply pipes, fit gripper rings, and install the flow regulator if needed.
Apply sealant and push the valve into position, securing with screws.
Refit shrouds, perform leak checks, and attach the shower hose.
Fit the on/off knob and decorative badge.
Prepare pipework, fit wall outlet, and secure it to the wall.
Drill for rail brackets and fit the handset holder.
Assemble shower rail, fit handset holder, and secure assembly to the wall.
Fit the hose restraint and rail end covers.
Instructions on using the on/off knob and temperature control lever for the concealed valve.
How to operate the shower controls for the exposed valve, including on/off and temperature.
Adjust spray patterns, water saving modes, and shower head height on the rail.
Recommended weekly procedure to activate the internal valve anti-scale mechanism.
Advice on cleaning the shower head, including dealing with limescale buildup.
Steps to reset the pre-set safe maximum shower temperature limit.
Reattaching the temperature lever and on/off knob after commissioning.
Adjusting the maximum shower temperature limit for the exposed valve.
Procedures for removing and refitting shrouds and control knobs.
Diagnosing and resolving problems with water temperature, flow rate, and output.
Solutions for poor flow, low temperature, and fluctuating water temperatures.
Identifies common reasons for reduced water flow and suggests corrective actions.
To Next Page
